101X: Electronics Nanocoating

$665.00$330,000.00

HYDROPHOBIC + OLEOPHOBIC ULTRA-THIN CONFORMAL COATING

NanoCoat 101X is an easy-to-apply liquid coating solution ideal for protecting electronics from moisture and corrosion. The PFOS/PFOA-free fluoropolymer liquid chemistry relies on a proprietary C6 fluorocarbon to provide hydrophobic and oleophobic properties to electronic substrates.

The solution is easily applied by dip, spray, spin, flow, or syringe coat, and suspended in a non-toxic, non-flammable, hydrofluoroether solvent that is compatible with a variety of materials. Minimal to no masking is required depending on assembly configuration. 101X dries in seconds to a thin, transparent film with excellent anti-wetting properties against liquids including water, oil, and a variety of chemicals such as heptane, toluene and acetone. 101X is an excellent product for electronic manufacturers, assemblers, and contract coating facilities to provide an effective solution at a lower cost.

Clear
SKU: N/A Category:

Features

  • shield-1-1

    Eco-friendly

  • shield-1-1

    Hydrophobic

  • shield-1-1

    Invisible

  • shield-1-1

    Non-toxic

  • shield-1-1

    No masking required

  • shield-1-1

    Easy application

  • shield-1-1

    Non-flammable

  • shield-1-1

    Dries to a transparent film

  • shield-1-1

    Non-toxic (PFOS & PFOA free)

  • shield-1-1

    Made in the USA

  • shield-1-1

    Chemical resistance

  • shield-1-1

    Can be soldered through

  • shield-1-1

    Hydrophobic (120º contact angle)

  • shield-1-1

    Oleophobic (80º contact angle)

  • shield-1-1

    Quality control – UV fluorescent dye

  • shield-1-1

    C6 fluorocarbon chemistry

  • shield-1-1

    Ready-to-use concentrations ranging from 0.5%-4.0%

  • shield-1-1

    Available as a 20% concentrate

  • shield-1-1

    Alternative formulation in an organic solvent is available

Where to use:

  • Consumer electronics

  • Ruggedized electronics

  • PCBAs

  • Sensors

  • Optics

  • Drone components

  • Avionics

  • Micro motors

  • Ball bearing tracks

  • Ink-jet print heads

  • Connectors

FAQs

C6

The coating can be used continuously at temperatures of 150°C and for about an hour at 250°C. The coating begins to decompose between 250°C -300°C.

No

The film is flexible and this property does not change over time.

Yes, it is added to the ready-to-use solution and will remain visible in the film.

Excitation: 373 nm; Emission: 460nm

The coating is breathable, and therefore gas permeable.

A soldering tip usually is between 600 and 800°C, which causes the film to transition to the gas phase and evaporate.

No, the coating is too thin.

The IPX scale rates water ingression into a device. Our coating can help your device achieve a level of IPX by preventing your phone from water damage. Our coating does not prevent water ingress into a device like a traditional case with mechanical seals, but instead prevents the electronics from failing when exposed to water.

No

Fluids, greases, creams, waxes, paints, glues, flux, etc. will dissolve due to the solvent, but will not affect the polymer as it is inert. These materials can be filtered and remove from the coating solution. It is recommended to perform a solids concentration analysis after filtering. It is recommended to avoid strong bases.